Description
Roll To Roll Electrode Coating Machine AME-SSC300A
- Installation For The Deposition Of Cathodes And Anode Electrodes LFP, LCO, LMO And Other System Batteries
- Maximum Cover Width – 360 Mm.
- Effective Coverage Width – ≤ 300 Mm(280mm)
- Mechanical Working Speed Of The Equipment 5 M / Min
- Two-Section Oven 6 Meters Long
- Speed Of Coating 0-5m / Min.
- Accuracy Of Applied Coating Thickness – ≤+/-0.003mm
- Slurry Viscosity – 2000 ~ 12000 Cps
- Minimum Spacing Length – 5 Mm
- Coating Method:Continuous Coating/Intermit Coating,One Side Coating And Then Another Side
- Application Foil:Aluminum Foil/Copper Foil
- All Part Contact With The Electrode Have Chrome Plating R Stainless Steel Corrosion Resistance
- Solvent Characteristics:
- Oil Solvent NMP (Sg = 1.033, Bp = 204 ℃)
- Aqueous Solvent H2O / NMP (Sg = 1.000, Bp = 100 ℃)
- Suitable For Solid Content:
- Anode S．S. 60% ± 5%
- S．C Cathode. 50% ± 5% (PVDF System)
- Cathode S. C. 50% ± 5% （SBR System）
- Proportion:
- Anode 1.5–2.59 / Cm2
- Cathode 1 ～ 1.89 / Cm2
- Supply Voltage – 380V.
- Air Source: 0.6-0.8Mpa
Integrated Unwinding, Head Mechanism
- Tension Control System – Automatic Closed-Loop Constant Tension Control, Tension Range 0 ~ 50N
- Correction Method – Automatic EPC Control, 50mm Stroke
- Material Rolling Method – The Roll Of Material Is Fixed With A 3-Inch Air Shaft. Unwinding Single Inflatable Shaft
- Direction Of Movement – Forward And Backward (Rewind)
- Max. Unwinding Diameter – Ф250mm
- Max. Bearing Capacity Of The Inflatable Shaft – 80 Kg
- Number Of Unwinding Inflatable Shafts. – 1
- Main Drive Motor – Servo Motor
- Roller Surface Treatment – Imported EPDM Roller, Wheel Runout ≤30um
- Control Panel – Touch Screen
- Front And End Mechanical Part For Quick Switch The Foil Roll
- With Mixing Shaft Which Move Left To Right
- Rectify System Which Will Ensure The Unwinding And Winding Aligned.
Requirements For A Two-Section Coating Drying Chamber.
- The Chamber Is Designed For Drying Coatings Immediately After Application To Roll Material By Means Of Intensive Air Flow At A Controlled Temperature.
- The Booth Should Be Integrated Into The Electrode Coater And Located Downstream Of The Coating System So That The Coated Roll Is Passed Through The Blow-Off Zones.
- The Number Of Blowing Zones In The Chamber Is 2 Pieces.
- The Length Of Each Zone Is At Least 3 Meters.
- The Air Temperature In Each Zone Is Regulated From Room Temperature To 150˚С.
- Each Zone Has Independent Temperature Control Of The Air Flow Through Mechanical Valves.
- The Heating Temperature And The Exhaust Fan Speed Can Be Control In PLC Touch Screen.
