Description

The Continuous Slitting Machine Is An Improved Product Based On Nishimura, Japan.
The Continuous Slitting Machine Adopts Blade-Type Knives, Cutting Without Burrs, And Adopts A Cantilever Structure Knife Holder, Which Is Convenient For Combination And Change Of Knives. 

• Power Requirements: 380V/Three-Phase/50Hz, Power: 4KW
• Compressed Air: Pressure: 0.6 MPa, Flow: 0.04 M3/Min;
• Cutting Material: 9-30μm Copper Foil Or Aluminum Foil, With Electrode Material Coated On Both Sides, After Drying And Rolling, The Thickness Of The Battery Pole Piece Is 50~300μm;
• Unwinding Method: Single-Axis Passive Unwinding, Automatic Correction, Constant Tension Control;
• Maximum Unwinding Width: 660mm;
• Unwinding Diameter: The Maximum Is Not Less Than 500mm;
• Width Of Guide Roller: ≥750mm;
• Transmission Speed: Mechanical Speed: 50m/Min, Continuously Adjustable.
• Slitting Accuracy: ±0.1mm;
• Material Rewinding: Upper And Lower Double Shaft Rewinding, Rewinding Diameter: Maximum Not Less Than Φ500mm;
• Total Weight Of Equipment: About 2T,
• Ground Load-Bearing Requirements For Equipment Installation:> 1.5T/M2, And A Pad (Provided By The Supplier) Should Be Placed At The Bottom Of The Equipment.
• Equipment Size: Approximately 2050mm In Length×1800mm In Width×1600mm In Height.